NEC univerge sv8100 User Manual page 396

Issue 7.00
3 - 388
47-01-08 Delay in Dialing Digital Pager Callback Number (Pager Dial Delay)
Use this option to set the delay (0~99 seconds) that occurs just before
InMail dials the Digital Pager Callback Number portion of the Message
Notification callout number for a digital pager. Set this delay so the pager
service has enough time to connect to the digital pager before sending the
callback number. Your pager service may be able to help you determine the
best value for this option (0~99 seconds). By default, this option is 9
seconds. When placing a digital pager notification, the system:
1. Seizes the trunk specified.
2. Dials user-entered notification number (in Message + OP + N).
3. Waits the 47-01-08 Delay in Dialing Digital Pager Callback
Number interval.
4. Dials number entered in 47-01-07 Digital Pager Callback
Number.
The system assumes that the notification number completes dialing
approximately 4 seconds after trunk seizure. This means that, by default,
the Digital Pager Callback Number is dialed to the pager service about 13
seconds after trunk seizure.
Note: this is not applicable in Europe.
.
See Message Notification on page 2-271
.
Options
0~99 seconds
Default
9 seconds
47-01-09 Wait Between Digital Pager Callout Attempts (Notify Pager Intvl)
Use this option to set the minimum time (1~255 minutes) between
unacknowledged or unanswered digital pager Message Notification
callouts. (A subscriber acknowledges a digital pager notification by logging
onto their mailbox.) After this interval expires, InMail tries the callout again
(for up to the number of times set in 47-01-14 Number of Callout Attempts).
If the system dials the callout number and the pager service is busy, it will
retry the number in one minute.
Note: this option is not available in Europe.
.
See Message Notification on page 2-271
.
Options
1~255 minutes
Default
15 minutes
for more.
for more.
Programming