NEC univerge sv8100 User Manual page 90

Issue 7.00
2 - 82
0 = Normal
1 = VRS (second dial tone if no VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode Switching (default = 0)
22-05-01 Incoming Trunk Ring Group Assignment
Assign trunks to incoming Ring Groups. Use this program to assign Normal
Ring Trunks (Program 22-02) to Incoming Ring Groups (Program 22-04).
It sets arriving group of the outside line set by Program 22-02 as "General
arrival call".
22-11-05/06DID Translation Table Number - Transfer Destination Number 1/2
For each DID Translation Table entry (1-2000), specify the first and second
Transfer Destinations if the callers receives a busy or no answer (action
defined in Program 22-11-04).
If the Transfer Destinations
.
to the final transfer destination (Program 22-10).
Entries
0 = No Setting
1~100 = Incoming Group
101 = (Not Used)
102 = In-Skin/External
Voice Mail or InMail
103 = Centralized VM
201~264 = Department Group
400 = DUD
401 = DISA
501~599 = DISA/VRSMessage
1000~999 = Speed Number (000~999)
(default = 0)
25-03-01 VRS/DISA Transfer Ring Group With Incorrect Dialling
For each trunk port, set what happens to a call when the DISA or
Automated Attendant caller dials incorrectly or waits too long to dial. The
call can either disconnect (0) or Transfer to an alternate destination (a ring
group, In-Skin/External, Centralized).
When setting the DISA and DID Operating Mode, you make anntry for each
Night Service mode.
This program defines the Incoming Ring Group when dial tone is timed-out
or the wrong dialing is received in DID, DISA.
are busy or receive no answer, those calls are transferred
Features