Mount The Drive; Install The Wiring - ABB ACS550-01 User Manual

ACS550 User's Manual

Mount the Drive

1. Position the ACS550 onto the mounting screws
or bolts and securely tighten in all four corners.
Note! Lift the ACS550 by its metal chassis.
2. Non-English speaking locations: Add a warning
sticker in the appropriate language over the
existing warning on the top of the module.

Install the Wiring

Conduit/Gland Kit
Wiring drives requires a conduit/gland kit with the following items:
• conduit/gland box
• five (5) cable clamps (ACS550-01 only)
• screws
• cover
Overview
As you install the wiring, observe the following:
• "Connection Diagrams" on page 16 shows the connection points on the drive.
• "Power Connections" on page 20 describes specific instructions for wiring the
power. Use in combination with the appropriate general procedure.
• "Control Connections" on page 20 describes specific instructions for wiring the
control. Use in combination with the appropriate general procedure.
• "Optional Braking" on page 20, and "Floating Networks" on page 20 describe
specific instructions for use as appropriate.
• "Cable Terminals" on page 129 list the recommended tightening torques.
• Where applicable, observe EMC recommendations. For example, properly
ground the wire screen cable shields.
1
2
IP2002
Installation
15