Toshiba Q9 Installation And Operation Manual page 83

F120
LI2 Terminal
Program  Input Terminals
This parameter is used to set the functionality of the LI2 discrete input terminal.
In addition, this input terminal must be specified as Normally Open or Normally
Closed.
This setting assigns the function of the programmable LI2 terminal to any of the
user-selectable functions listed in
Note: The Expansion IO Card Option 1 Option Board (P/N ETB003Z) is
required to use this terminal.
See the Expansion IO Card Option 1 Instruction Manual (P/N 58685) for more
information on the function of this terminal.
LI3 Terminal
Program  Input Terminals
This parameter is used to set the functionality of the LI3 discrete input terminal.
In addition, this input terminal must be specified as Normally Open or Normally
Closed.
This setting assigns the function of the programmable LI3 terminal to any of the
user-selectable functions listed in
Note: The Expansion IO Card Option 1 Option Board (P/N ETB003Z) is
required to use this terminal.
See the Expansion IO Card Option 1 Instruction Manual (P/N 58685) for more
information on the function of this terminal.
LI4 Terminal
Program  Input Terminals
This parameter is used to set the functionality of the LI4 discrete input terminal.
In addition, this input terminal must be specified as Normally Open or Normally
Closed.
This setting assigns the function of the programmable LI4 terminal to any of the
user-selectable functions listed in
Note: The Expansion IO Card Option 1 Option Board (P/N ETB003Z) is
required to use this terminal.
See the Expansion IO Card Option 1 Instruction Manual (P/N 58685) for more
information on the function of this terminal.
Q9 ASD Installation and Operation Manual
Table 4 on pg. 186.
Table 4 on pg. 186.
Table 4 on pg. 186.
Direct Access Number — F120
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
Direct Access Number — F121
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
Direct Access Number — F122
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
F122
73