Toshiba Q9 Installation And Operation Manual page 85

Asd
Table of Contents

Advertisement

F126
LI8 Terminal
Program  Input Terminals
This parameter is used to set the functionality of the LI8 discrete input terminal.
In addition, this input terminal must be specified as Normally Open or Normally
Closed.
This setting assigns the function of the programmable LI8 terminal to any of the
user-selectable functions listed in
Note:
The Expansion IO Card Option 2 Option Board (P/N ETB004Z) is
required to use this terminal.
See the Expansion IO Card Option 2 Instruction Manual (P/N 58686) for more
information on the function of this terminal.
OUT1 Terminal
Program  Output Terminals
This parameter is used to set the functionality of the OUT1 discrete output
terminals O1A and O1B.
The O1A and O1B (OUT1) output terminals change states (open or close) as a
function of a user-selected event. See
assignments for the OUT1 terminals.
In addition, the output terminals must be specified as Normally Open or
Normally Closed.
OUT2 Terminal
Program  Output Terminals
This parameter is used to set the functionality of the OUT2 discrete output
terminals O2A and O2B.
The O2A and O2B (OUT2) output terminals change states (open or close) as a
function of a user-selected event. See
assignments for the OUT2 terminals.
In addition, the output terminals must be specified as Normally Open or
Normally Closed.
FL Terminal
Program  Output Terminals
This parameter is used to set the functionality of the FL output terminals to 1 of
the functions listed in
Table 7 on pg.
In addition, the output terminals must be specified as Normally Open or
Normally Closed.
Q9 ASD Installation and Operation Manual
Table 4 on pg.
186.
Table 7 on pg. 190
for listing the possible
Table 7 on pg. 190
for listing the possible
190.
Direct Access Number — F126
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
Direct Access Number — F130
Parameter Type — Selection List
Factory Default — Damper Command
Changeable During Run — No
Direct Access Number — F131
Parameter Type — Selection List
Factory Default — RCH (Acc/Dec
Complete)
Changeable During Run — No
Direct Access Number — F132
Parameter Type — Selection List
Factory Default — Fault (All)
Changeable During Run — No
F132
75

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents