Toshiba Q9 Installation And Operation Manual page 87

F136
OUT5 Terminal
Program  Output Terminals
This parameter is used to set the functionality of the OUT5 discrete output
terminal.
In addition, this output terminal must be specified as Normally Open or
Normally Closed.
This setting assigns the function of the programmable OUT5 terminal to any of
the user-selectable functions listed in
Note: The Expansion IO Card Option 2 Option Board (P/N ETB004Z) is
required to use this terminal.
See the Expansion IO Card Option 2 Instruction Manual (P/N 58686) for more
information on the function of this terminal.
OUT6 Terminal
Program  Output Terminals
This parameter is used to set the functionality of the OUT6 discrete output
terminal.
In addition, this output terminal must be specified as Normally Open or
Normally Closed.
This setting assigns the function of the programmable OUT6 terminal to any of
the user-selectable functions listed in
Note: The Expansion IO Card Option 2 Option Board (P/N ETB004Z) is
required to use this terminal.
See the Expansion IO Card Option 2 Instruction Manual (P/N 58686) for more
information on the function of this terminal.
R2 Terminal
Program  Output Terminals
This parameter is used to set the functionality of the R2 discrete output terminal.
In addition, this output terminal must be specified as Normally Open or
Normally Closed.
This setting assigns the function of the programmable R2 terminal to any of the
user-selectable functions listed in
Note: The Expansion IO Card Option 2 Option Board (P/N ETB004Z) is
required to use this terminal.
See the Expansion IO Card Option 2 Instruction Manual (P/N 58686) for more
information on the function of this terminal.
Output Terminal 10 (R3) Function
No Path — Direct Access Only
This parameter sets the functionality of the R3 output terminal to any of the user-
selectable functions listed in
In addition, the output terminals must be specified as Normally Open or
Normally Closed.
See the instruction manual for the 16-Bit BIN/BCD option for more information
on the function of this terminal.
Q9 ASD Installation and Operation Manual
Table 7 on pg. 190.
Table 7 on pg. 190.
Table 7 on pg. 190.
Table 7 on pg. 190.
Direct Access Number — F136
Parameter Type — Selection List
Factory Default — Always Off
Changeable During Run — No
Direct Access Number — F137
Parameter Type — Selection List
Factory Default — Always Off
Changeable During Run — No
Direct Access Number — F138
Parameter Type — Selection List
Factory Default — Always Off
Changeable During Run — No
Direct Access Number — F168
Parameter Type — Selection List
Factory Default — OFF
Changeable During Run — No
F168
77