Error Code; Reception - NEC NEFAX 671 Service Manual

7-2.

Error Code

(1)

Reception

Code
0001 No G3 signal received within 35 sec. in manual receive mode.
0003 Received DIS after sending DIS signal.
0004 Received DCN after sending DTC signal.
0006 Detect busy tone within receiving phase B.
0009 Can not receive any signal within 35 sec. in manual polling mode.
0010 Received DCN signal after sending DTC signal in polling RX.
0011 Can not receive any correct response after sending three DTC signals.
0012 Remote side Password does not match in polling RX/our side no file to be polled.
0013 Can not receive carrier signal within 6 sec. after sending CFR in data phase C.
0014 Can not receive T.30 signal after sending FTT signal.
0015 Line polarity change within receiving phase B~D.
0016 Receive DCN signal after sending FTT signal.
Can not receive any response from remote side after sending type of xxx_EOM
0017
signal.
0018 Can not detect energy within 6 sec. after sending FTT command.
0019 Received DCN signal after sending CFR signal.
001A No energy on line over 6 sec. within phase C before any corrected ECM frame.
001D Detect FSK signal, but did not receive any command within 6 sec.
In phase C, have detected FSK signal, but did not receive any command within 6
001E
sec.
Can not correct frame within 6 sec., or in non-ECM mode, one decoding line over
0020
6 sec.
0021 Remote-side disconnect at phase C (V.17).
Owing to noise interference on the line, receiving side can't receive correct data
0022
within specified time (no ECM).
- Received "Remote monitoring password" error in RSD.
☞ S-32
"Utility mode/ Admin.management/ Remote monitor".
☞ S-103
"Service mode/ Admin. registration."
0023
- The Customer machine has updated the firmware now.
- The Service Tech. Rep. updated remote machine firmware by RSD.
- TX and RX machines both have different "machine ID (FAX model ID)" code in
RSD.
0024
- The Customer machine has updated the firmware now.
- The Service Tech. Rep. updated remote machine firmware by RSD
- TX and RX machines have different "company ID (FAX machine maker ID)"
code in RSD.
0025
- The Customer machine has updated the firmware now.
- The Service Tech. Rep. updated remote machine firmware by RSD
Possible Causes of Error.
T-39