(3)
Removal of the Controller/Mechanical Control Board
<Removal Procedures>
1. Remove the Rear Cover.
☞ D-7
2. Remove the Network Interface Card Board. (NEFAX 691 only)
☞ D-11
3. Remove the Network Control Unit Board.
☞ D-11
4980D003AC
4980D004AB
(4)
Removal of the Control Panel
1. Remove the Exit tray.
☞ D-7
4136D047AA
4. Disconnect all connectors and flat cables from
the Controller/Mechanical Control Board.
NOTES
• Use utmost care not to snap off the flat cable.
5. Remove six screws.
6. Remove the Controller/Mechanical Control
Board.
2. Remove the Rubber cap, then remove the three
screws.
3. Unplug one connector and one flat cable.
4. Remove the Control Panel.
NOTE
• Use utmost care not to snap off the flat cable.
D-12