Installing Firmware; Setting By Country; Initializing The Eeprom Of The Main Pcb Assy - Brother ADS-2600W Service Manual

1.1.2 Installing firmware

(1) Press and hold the
Check that the Back LED is lit, and release these two buttons.
(2) Press the
is displayed on the LCD. The machine enters firmware installing mode.
(3) Connect the machine to your computer using the USB cable.
(4) Turn ON the power switch of the computer.
(5) Open the temporary folder and double-click "Filedg32.exe" to start it, then select the
"Brother Maintenance USB Printer".
(6) Drag and drop the panel main firmware (LZXXXX_$.upd) in the same folder onto the
"Brother Maintenance USB Printer" icon. The firmware file is loaded to the machine, and
installing to the flash ROM starts.
(7) All LED flash randomly during installing. When installing is completed, the machine
restarts and returns to the ready state automatically. Do not disconnect the USB cable or
turn OFF the power switch of the computer until installing is completed.
(8) Disconnect the USB cable, and unplug the AC power cord of the machine.
(9) Press and hold the
Check that the Back LED is lit, and release these two buttons.
(10) Press the
is displayed on the LCD. The machine enters firmware installing mode.
(11) Connect the machine to your computer using the USB cable.
(12) Open the temporary folder and double-click "Filedg32.exe" to start it, then select the
"Brother Maintenance USB Printer".
(13) Drag and drop the main firmware (LZXXXX_$.upd) in the same folder onto the "Brother
Maintenance USB Printer" icon. The firmware file is loaded to the machine, and installing
to the flash ROM starts.
(14) All LED flash randomly during installing. When installing is completed, the machine
restarts and returns to the ready state automatically. Do not disconnect the USB cable or
turn OFF the power switch of the computer until installing is completed.
(15) Unplug the AC power cord of the machine, and disconnect the USB cable.
1.2

Setting by Country

(1) Check the country code to set in the country code table on page "5-16".
(2) Press the [7], and then the [4] key in the maintenance mode. The country code is
displayed on the LCD.
(3) Enter the country code checked in (1).
(4) Press the [Start] key. The country code is set, and the machine returns to the initial state
of maintenance mode.
1.3

Initializing the EEPROM of the Main PCB ASSY

(1) Press the [0], and then the [1] key in the initial state of maintenance mode.
"PARAMETER INIT" is displayed on the LCD, and the EEPROM is initialized. The
machine returns to the initial state of maintenance mode.
and buttons, and plug the AC power cord into the outlet.
, and then the button. The Home LED light, and "
and buttons, and plug the AC power cord into the outlet.
, and then the button. The Home LED light, and "
4-3
          
"
          
"
Confidential