Brother ADS-2600W Service Manual page 41

Error code 3C00 to A100

These errors do not usually occur during normal use. The possible causes are noise around
the installation site, fluctuation of the power supply voltage, and failures in the software.
---
An unidentified error occurred.
Step
1 Main PCB failure
 Error code A200
Document Jam/too Long
See Troubleeshooting in Use's Guide.
The document scanning position sensor detected that the document length was 40 cm or
more while scanning a document.
<User Check>
• Set the document length within the standard.
Step
Document scanning position
1 actuator caught in sections of
the machine
Document scanning position
2
sensor failure
3 Main PCB failure
 Error code A300
Document Jam/too Long
See Troubleeshooting in Use's Guide.
The document scanning position sensor has not detected the top of the document even after
the document has been fed for the specified distance.
<User Check>
• Set the document in the ADF correctly.
Step
Document scanning position
1
actuator coming off
Document scanning position
2
sensor failure
3 Main PCB failure
Cause
Replace the main PCB ASSY.
Cause
Reattach the document scanning position
actuator.
Replace the document scanning position
sensor PCB ASSY.
Replace the main PCB ASSY.
Cause
Reattach the document scanning position
actuator.
Replace the document scanning position
sensor PCB ASSY.
Replace the main PCB ASSY.
2-15
Remedy
Remedy
Remedy
Confidential