Set Worker Switches (Wsw) (Function Code: 10) - Brother ADS-2600W Service Manual

1.3.3 Set worker switches (WSW) (function code: 10)

<Function>
Worker switches shown in the table below can be used to set functions to satisfy various
requirements. The switch setting can be changed using the buttons on the control panel.
Worker switches are factory set to conform with the laws and regulations of the country the
machine is shipped to. Do not change these settings unless necessary.
List of worker switches
WSW No.
WSW17
WSW28
WSW32
WSW43
WSW44
WSW46
WSW47
WSW48
WSW56
WSW59
WSW60
WSW63
WSW64
WSW79
WSW82
WSW83
* Refer to the separate manual for details of worker switches.
* Worker switches not on the list can be typed but nothing happens even if the value is changed.
<Operating Procedure>
(1) Press the [1], and then the [0] key in the initial state of maintenance mode. "WSW00" is
displayed on the LCD.
(2) Enter the worker switch number that you want to change the setting.
The display shown below appears on the LCD. The "Selector No.1" flashes.
Selector No.1
WSWXX = 0 0 0 0 0 0 0 0
(3) Press the [
the [1] or [0] key.
(4) When changing the setting is completed, press the [SET] key. The new selector setting
value is stored in the EEPROM, and the LCD returns to the ready state for worker switch
number entry ("WSW00").
(5) When all switch setting is completed, press the
initial state of maintenance mode.
Note:
• To cancel operation and return to the initial state of maintenance mode, press the
button.
• If there is no entry for one minute or longer on the 2-digits firmware switch number selection,
the machine returns to the initial state of maintenance mode automatically.
Clock setting 1
Setting resolution for when flex memory is used depends on memory size
Resolution/contrast home position
Remote maintenance auto start setting
Available correction time before scanning
Dust removal/waiting time for scanning
Switching between high- and full-speed USB
USB setup latency
ON/OFF setting for wireless LAN and CPU sleep function
ON/OFF setting for USB serial number (SN) sending function
Setting touch panel repeat start time and its interval
Clock setting 2
Language setting
Reboot suppression for when touch panel was found operable
Blank paper removal/auto color number detection
Size detection and skew correction
Selector No.8
] or [ ] key to flash the desired selector, and change the setting by pressing
Function
button to return the machine to the
5-6
Confidential