Toshiba TOSVERT VF-AS3 Instruction Manual page 140

■ Setting of parameter for which an item should be selected
For an example, here is a procedure to set an extended parameter <F710: Standard mode display>.
1 Press the [ESC] key to change from [Standard
mode] to [Setting mode].
In the example on the right, the operation panel is
in [Standard mode], and the output frequency is
displayed in the middle of the screen.
• To switch from [Monitor mode], press the [F3] key
("Setting").
• Switch from [Easy mode] to [Standard mode] or
4
[Monitor mode]. For details of switching of
display modes, refer to [3. 1. 2].
The [Setting mode] screen is displayed.
Memo
9
2 Select "5. Extended parameter (F---)" with the
touch wheel.
The selected item is highlighted.
3 Press the [OK] key.
The extended parameter screen is displayed. The
screen showing the list of each category with 100
parameters is displayed.
4. [Basic operation] Operation methods of motor
• If [Setting mode] is not displayed on the screen even after the above operation, check the
<PSEL: Parameter mode select> setting. When "2: Easy mode only" is set, change the setting.
For details, refer to [5. 2. 8].
Easy
1. History function
2. Direct access
3. Guidance function
4. Basic parameters
5. Extended parameters(F - - -)
Top
1. History function
2. Direct access
3. Guidance function
4. Basic parameters
5. Extended parameters(F - - -)
Top
Extended parameters (F ---)
Input/output parameters (F1 - -)
3.1
Frequency parameters (F2 - -)
3.2
Operation parameters (F3 - -)
3.3
Motor parameters 1 (F4 - -)
3.4
Acc/dec parameters (F5 - -)
3.5
Top
4-16
E6582062
STOP 0.0Hz F R
14:47
Standard Mode
0.0
Hz
Screen Copy Monitor
STOP 0.0Hz
14:00
Setting Mode
Easy Monitor
STOP 0.0Hz
15:07
Setting Mode
Monitor
STOP 0.0Hz
14:36
0
Monitor