Toshiba TOSVERT VF-AS3 Instruction Manual page 159

The basic parameter screen is displayed.
Check that the setting value of <FMOd: Frequency
command select 1> is "1."
In this setting, the voltage signal input to the
terminal [RR] should be the frequency command.
Here, the voltage input to the terminal [RR] is
adjusted with the potentiometer.
12 Press the [ESC] key or [F1] to [F4] keys to switch
to the [Standard mode] screen.
In the main area of the [Standard mode] screen, the output frequency (0.0 Hz) is displayed.
13 Turn on the external switch.
14 When you rotate the potentiometer, the frequency
command value increases, and the motor starts
running.
The following are always displayed in the status
area on the upper side of the screen regardless of
display mode. (From the left)
• The icon is rotating
• Operation status "RUN"
• Frequency command (display contents vary
depending on the setting of the parameter)
• Run command icon
• In some cases, for example, when the potentiometer is set to the maximum/minimum, you can
Memo
set the two frequency command points. The default setting is 0.0 Hz/60.0 Hz. For details, refer
to [7. 3. 2].
15 When you turn off the external switch, the motor decelerates and stops.
F R
4-35
STOP 0.0Hz
Basic parameters
: Run command select
CMOd
: Frequency command select 1
FMOd
: V/f Pattern
Pt
: Manual torque boost 1
vb
: Base frequency 1
vL
PP
MAX
: Frequency settings
RR
by potentiometer
MIN
CC
Output frequency
60Hz
0
MIN
RUN 60.0Hz
RUN 30.0Hz
Standard Mode
Top View Mode
60.0
60.0
Easy Keypad Copy
Easy Screen Copy
4. [Basic operation] Operation methods of motor
E6582062
F R
15:55
0
1
0
4.80%
60.0Hz
3
4
9
MAX
F R
20:52
16:14
Hz
Hz
Monitor
Monitor