Using Sol Over Openssh With Linux - Dell iDRAC6 User Manual

3 Enter the following command at the command prompt to start SOL:
connect
4 To quit a SOL session from Telnet on Linux, press <Ctrl>+] (hold down
the control key, press the right-square-bracket key, and then release).
A Telnet prompt displays. Enter quit to exit Telnet.

Using SOL over OpenSSH with Linux

OpenSSH is an open source utility for using the SSH protocol. To start SOL
from OpenSSH on a Linux management station, follow these steps:
NOTE:
If required, you can change the default SSH session timeout at System→
Remote Access→ iDRAC6→ Network/Security→ Services.
1 Start a shell.
2 Connect to iDRAC6 with the following command:
ssh < iDRAC-ip-address > -l < login name >
3 Enter the following command at the command prompt to start SOL:
connect
NOTE:
session is established successfully, iDRAC6 command line console is no
longer available to you. Follow the escape sequence properly to reach
iDRAC6 command line console. Quit the SOL session (refer to "Disconnecting
SOL session in iDRAC6 Command Line Console" to close an active SOL
session).
Using SOL over IPMItool
The Dell Systems Management Tools and Documentation DVD provides the
IPMItool which can be installed on various operating systems. See the
Software Quick Installation Guide for installation details. To start SOL with
IPMItool on a management station, follow these steps:
NOTE:
If required, you can change the default SOL timeout at System→ Remote
Access→ iDRAC6→ Network/Security→ Services.
1 Locate IPMItool.exe under the proper directory.
The default path in Windows 32–bit operating system is C:\Program
Files\Dell\SysMgt\bmc and in Windows 64–bit operating system is
C:\Program Files (x86)\Dell\SysMgt\bmc.
194
Configuring and Using Serial Over LAN
This connects you to the managed server's serial port. Once a SOL