Configuring E-Mail Alerts - Dell iDRAC6 User Manual

Enter an IP address in the appropriate IPv4 or IPv6 Destination IP
b
Address box.
NOTE:
community string.
Click Apply.
c
NOTE:
The Community String value indicates the community string to use in a Simple
Network Management Protocol (SNMP) alert trap sent from iDRAC6. SNMP
alert traps are transmitted by iDRAC6 when a platform event occurs. The
default setting for the Community String is Public.
To test the configured alert, click Send.
d
To add an additional destination IP address, repeat step a through
e
step d. You may specify up to four IPv4 and four IPv6 destination
addresses.

Configuring E-Mail Alerts

1 Log in to iDRAC6 Web interface.
2 Ensure that you followed the procedures in "Configuring Platform Event
Filters (PEF)."
3 Click System, and then click the Alert Management tab.
The Platform Events screen appears.
4 Click Email Alert Settings.
The Email Alert Settings screen appears.
5 Configure your e-mail alert destination.
Select the Enabled check box for the first undefined email alert.
a
Enter a valid email address in the Destination Email Address field.
b
Click Apply.
c
NOTE:
Address must be configured in the SMTP (Email) Server Address Settings
section of the Email Alert Settings screen. The IP address of the SMTP Server
communicates with iDRAC6 to send e-mail alerts when a platform event
occurs.
Click Send to test the configured e-mail alert (if desired).
d
96
Configuring iDRAC6 Enterprise Using the Web Interface
The destination community string must be the same as iDRAC6
To successfully send a trap, configure the Community String value.
To successfully send a test e-mail, the SMTP (Email) Server IP