Siemens SINUMERIK 840D sl Operating Manual page 11

6.15.2 Starting the mold making view.............................................................................................220
6.15.3 Adapting the mold making view...........................................................................................220
6.15.4 Specifically jump to the program block.................................................................................221
6.15.5 Searching for program blocks..............................................................................................222
6.15.6 Changing the view................................................................................................................223
6.15.6.1 Enlarging or reducing the graphical representation.............................................................223
6.15.6.2 Moving and rotating the graphic...........................................................................................224
6.15.6.3 Modifying the viewport.........................................................................................................224
6.16 Displaying the program runtime and counting workpieces...................................................225
6.17 Setting for automatic mode..................................................................................................227
7 Simulating machining...............................................................................................................................231
7.1 Overview..............................................................................................................................231
7.2 Simulation before machining of the workpiece.....................................................................238
7.3 Simultaneous recording before machining of the workpiece................................................239
7.4 Simultaneous recording during machining of the workpiece................................................239
7.5 Different views of the workpiece..........................................................................................240
7.5.1 Plan view..............................................................................................................................240
7.5.2 3D view................................................................................................................................241
7.5.3 Side view..............................................................................................................................241
7.6 Editing the simulation display...............................................................................................242
7.6.1 Blank display........................................................................................................................242
7.6.2 Showing and hiding the tool path ........................................................................................243
7.7 Program control during the simulation.................................................................................243
7.7.1 Changing the feedrate .........................................................................................................243
7.7.2 Simulating the program block by block................................................................................244
7.8 Changing and adapting a simulation graphic.......................................................................245
7.8.1 Enlarging or reducing the graphical representation.............................................................245
7.8.2 Panning a graphical representation.....................................................................................246
7.8.3 Rotating the graphical representation..................................................................................246
7.8.4 Modifying the viewport.........................................................................................................247
7.8.5 Defining cutting planes.........................................................................................................248
7.9 Displaying simulation alarms................................................................................................248
8 Generating a G code program..................................................................................................................251
8.1 Graphical programming........................................................................................................251
8.2 Program views.....................................................................................................................251
8.3 Program structure................................................................................................................255
8.4 Fundamentals......................................................................................................................256
8.4.1 Machining planes.................................................................................................................256
8.4.2 Current planes in cycles and input screens.........................................................................257
8.4.3 Programming a tool (T)........................................................................................................257
8.5 Generating a G code program.............................................................................................258
8.6 Blank input...........................................................................................................................259
Milling
Operating Manual, 05/2017, A5E40868956
Table of contents
11