Note
Deleting logbook entries
Up to the completion of the 2nd commissioning, you have the option to delete the logbook
entries up to the time of the first commissioning using the "Clear" softkey.
Searching for a logbook entry
You have the option for searching for specific entries using the search function.
Additional search option
15.9
Remote diagnostics
15.9.1
Setting remote access
You can influence the remote access to your control in the "Remote diagnostics (RCS)"
window.
You set the rights for all remote operating types in this window. The selected rights are defined
from the PLC and using the setting at the HMI.
The HMI can restrict the rights specified from the PLC, but however, cannot extend the rights
beyond the PLC rights.
If the settings made permit access from outside, then this is still dependent on a manual or
automatic confirmation.
Milling
Operating Manual, 05/2017, A5E40868956
1.
The "Machine logbook" window is opened.
2.
Press the "Find" softkey.
3.
Enter the desired term in the search form. You can make a search ac‐
cording to date/time, company name/department or according to fault di‐
agnostics/measure.
The cursor is positioned on the first entry that corresponds to the search
term.
4.
Press the "Continue search" softkey if the entry found is not the one that
you are looking for.
Press the "Go to Beginning" softkey to start the search at the latest entry.
Press the "Go to End" softkey to start the search at the oldest entry.
Alarm, error, and system messages
15.9 Remote diagnostics
749