Changing The User Interface Language - Siemens SINUMERIK 840D sl Operating Manual

Channel switchover
Cancelling alarms
Calling up the online help
2.4.11

Changing the user interface language

Procedure
Note
Changing the language directly on the input screens
You can switch between the user interface languages available on the controller directly on
the user interface by pressing the key combination <CTRL + L>.
Milling
Operating Manual, 05/2017, A5E40868956
You can switch over to the next channel by touching the channel display
in the status display.
Touch operation of the Alarm Cancel icon will cancel the displayed alarm.
Touch operation of the information icon in the status display will open the
online help.
1. Select the "Start-up" operating area.
2. Press the "Change language" softkey.
The "Language selection" window opens. The language set last is selec‐
ted.
3. Position the cursor on the desired language.
4. Press the "OK" softkey.
- OR -
Press the <INPUT> key.
The user interface changes to the selected language.
Introduction
2.4 User interface
51