Removing A Tool From Multitool - Siemens SINUMERIK 840D sl Operating Manual

Procedure
Equipping the multitool with a new tool
Loading the multitool
Loading the tool into the multitool
13.16.4

Removing a tool from multitool

If the multitool was mechanically re-equipped, then the old tools in the tool list must be removed
from the multitool.
To do this, the cursor is positioned at the line where the tool which is to be removed is located.
When unloading, the tool is automatically saved in the tool list outside the magazine in the NC
memory.
Milling
Operating Manual, 05/2017, A5E40868956
1. The tool list is opened.
2. Select the required multitool, position the cursor on an empty mul‐
titool location.
3. Press the "New tool" softkey.
4. Using the appropriate selection list, e.g. favorites, select the re‐
quired tool.
2. Select the required multitool, position the cursor on an empty mul‐
titool location.
3. Press the "Load" softkey.
The "Load with..." window opens.
4. Select the required tool.
2. Position the cursor on the tool that you want to load into the multi‐
tool.
3. Press the "Load" and "Multitool" softkeys.
The "Load on ..." window opens.
4. Select the required multitool and the multitool location to which you
wish to load the tool.
Tool management
13.16 Working with Multitool
675