Toshiba GRT100 Series Instruction Manual page 86

(If a numerical value outside the displayed range is entered, "Error: Out of range" appears on
the top line and the cursor remains on the line. Press the CANCEL key to clear the entry.)
 After completing the setting on the screen, press the END key to return to the upper screen.
To correct the entered numerical value, do the following.
 If it is before pressing the ENTER key, press the CANCEL key and enter the new
numerical value.
 If it is after pressing the ENTER key, move the cursor to the correct line by pressing the
and keys and enter the new numerical value.
Note: If the CANCEL key is pressed after any entry is confirmed by pressing the ENTER key, all
the entries made so far on the screen concerned are canceled and the screen returns to the upper
one.
To enter a text string
Text strings are entered in the bracket under the "Plant name" or "Description" screen.
To select a character, use keys 2, 4, 6 and 8 to move the blinking cursor down, left, right and up.
"" and "" on each of lines 2 to 4 indicate a space and backspace, respectively. A maximum of
22 characters can be entered within the brackets.
/ 3 P l a n t
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
a b c d e f g h i j k l m n o p q r s t u v w x y z
0 1 2 3 4 5 6 7 8 9
 Set the cursor position in the bracket by selecting "" or "" and pressing the ENTER
key.
 Move the blinking cursor to select a character.
 Press the ENTER to enter the blinking character at the cursor position in the brackets.
 Press the END key to confirm the entry and return to the upper screen.
To correct the entered character, do either of the following.
 Discard the character by selecting "" and pressing the ENTER key and enter the new
character.
 Discard the whole entry by pressing the CANCEL key and restart the entry from the first.
To complete the setting
Enter after making entries on each setting screen by pressing the ENTER key, the new settings
are not yet used for operation, though stored in the memory. To validate the new settings, take the
following steps.
 Press the END key to the upper screen. Repeat this until the confirmation screen shown
below is displayed. The confirmation screen is displayed just before returning to the "Setting
(change)" sub-menu.
n a m e [ _
! " # $ % & ' ：； ， ． ^ `
 85 
6 F 2 S 0 7 8 9
]
 
( ) [ ] @ _
 
{ } * / + - < = >
 