Section 9
DNP3 communication engineering
9.3
108
IEC11000425 V1 EN
Figure 75:
Selecting the signals into the DNP signal list
Configuring DNP3 protocol signals
1.
Save the actual project configuration in PCM600 to make all signals visible for
CMT.
Direct configured hardware channels in the application
configuration (see
not configure these hardware channels to be sent by DNP3, as
they are not event-handled.
Figure
76) appear in CMT (see
1MRK 511 284-UEN A
IEC11000425-1-en.vsd
Figure
77). Do
650 series
Engineering manual