Siemens SINUMERIK 840C Operator's Manual page 127

4 Machine
Notes
Table 4-5 Overview - Extended overstore
Mode
AUTOMATIC, JOG, TEACH IN
Extended overstore
Simple overstore
MDA mode
4-60
•
"Extended overstore" and "Overstore" are mutually exclusive.
•
If no disables have been configured by the machine-tool manufacturer NC
START is possible in "Extended overstore" without it being necessary to
reference the axes.
•
If a RESET or STOP is triggered on a mode change, the MDA1 program
is aborted with active "Extended overstore" of this RESET or STOP. The
state before "Extended overstore" was activated is not affected. "Extended
overstore" is not deselected (see channel display).
•
The following table shows when certain actions are possible:
Channel state
Running
RESET
NC STOP
Program stop
Running
RESET
NC-STOP
Program stop
Of no
significance
Of no
significance
•
If program control is changed during "Extended overstore", it is only
active for the "Extended overstore": After returning to the point of
interruption, the previous conditions again apply.
•
In operating mode TEACH IN, MDA mode in EDIT mode and "Extended
overstore" are interlocked.
6FC5198-6AA60-0BP1
Message
No extended overstore possible
Extended overstore
Extended overstore
Extended overstore
Termination not possible
Simple overstore not possible
Termination not possible
Simple overstore not possible
Termination not possible
Simple overstore not possible
Termination not possible
Simple overstore not possible
No extended overstore possible
No extended overstore possible
© Siemens AG 1999 All Rights Reserved
SINUMERIK 840C, OEM Version for Windows (BA)
01.99