Siemens SINUMERIK 840C Operator's Manual page 132

01.99
EXT
NCV
SAV
Restrictions
SKP
© Siemens AG 1999 All Rights Reserved
SINUMERIK 840C, OEM Version for Windows (BA)
Execution from external; Display: EXT (Option)
This function makes it possible to execute an NC program from the hard disk
or via computer link (see also the job list description).
Start of program/End cycles OFF: Display of NCY (no cycle)
Automatic processing of program start and end cycles can thus be interrupted.
Machine manufacturer
The machine manufacturer determines whether program start and end cycles
are used and (if this is the case) which subprograms are used.
Automatic saving; Display of SAV in the NCK editor
If this function is active, saving in the appropriate workpiece is started
automatically after edtiting of part programs in the NCK (e.g. with SK:
PROGRAM/NC editor or machine/program correction).
If no workpiece is known (new program), the modified program is stored in the
directory LOCAL/STANDARD.
Machine manufacturer
Via technology MD, the machine manufacturer can provide the workpiece
NCKTMP instead of STANDARD for this case.
To allocate an original workpiece, use the softkey SAVE ON DISK and enter
the workpiece name in the input line.
Note
With the setting date 5001.2=1 you can activate permanently the function
SAV (even after power on).
Automatic saving is not active in the TEACH IN operating mode. Saving is
performed only after program modification and leaving the efitor or area
switchover.
Skip block; Display SKP (Skip):
Blocks in the program which are marked by an oblique stroke in front of the
block number ("N...") are not taken into account when the program is run.
In addition to this skip block function, there are another 8 skip block levels /1
.../8. The skipping criteria can be entered before program execution is started.
They can also be configured by the machine manufacturer via the PLC
6FC5198-6AA60-0BP1
4 Machine
4-65