Output Of Individual Files; Input Of Files - Siemens SINUMERIK 840C Operator's Manual

01.99
6.2.6.2

Output of individual files

6.2.6.3

Input of files

6-30
To transfer an individual file of a workpiece to a peripheral device via the
RS232C (V24) interface, proceed as follows:
• Select the right-hand combo box with the EDIT key.
• Open the combo box with the RIGHT ARROW key.
• Use the ARROW keys to position the selection bar on an active device
name declared in "V24 Configuration".
• Press the INPUT key to enter the selected item in the right-hand combo
box.
• Select the left-hand combo box with the EDIT key.
• Open the combo box with the RIGHT ARROW key and use the vertical
ARROW keys to position the selection bar on the desired workpiece.
• Press the INPUT key to enter the selected workpiece in the combo box.
• Select the list box immediately underneath using the EDIT key.
• Position the selection bar on the desired file.
• Press the COPY softkey.
The data output is started, i.e. the V.24 interface is initialized and the selected
file is activated.
The Cancel V24 menu item is also enabled. The data transmission can be
cancelled at any time by pressing the appropriate softkey.
The data manager can be used to transfer NCK files to the hard disk via the
V24 interface. The files can be saved in a selected workpiece or in the
Clipboard:
• Select the left-hand combo box with the EDIT key.
• Open the combo box and position the selection bar on the desired
workpiece or on the "Clipboard" item.
• Press the INPUT key to enter the selected workpiece or the "Clipboard"
item in the left-hand combo box.
• Select the right-hand combo box with the EDIT key.
• Open the combo box and position the selection bar on an active device
name declared in "V24 Configuration".
• Press the INPUT key to enter the device name in the combo box. Note the
direction of the copy arrow.
6FC5198-6AA60-0BP1 © Siemens AG 1999 All Rights Reserved
SINUMERIK 840C, OEM Version for Windows (BA)
6 Programming