Siemens SINUMERIK 840C Operator's Manual page 209

01.99
Duplicating
6-24
Fig. 6-11 Delete Workpiece dialog box
• Confirm deletion with the YES softkey.
The Duplicate function can be used to duplicate individual files of the
currently selected workpiece or the NC program memory.
• Select one of the two combo boxes with the EDIT key.
• Open the combo box with the RIGHT ARROW key.
• Use the vertical ARROW keys to position the selection bar on the
workpiece or on "NC Program Memory". You can select "NC Program
Memory" in the right-hand combo box only.
• Press the INPUT key. The selected item is entered in the combo box.
• Select the list box below the combo box using the EDIT key.
• Use the vertical arrow keys to position the selection bar on the file to be
duplicated.
• Press the DUPLICATE softkey. The following extra input boxes appear.
Fig. 6-12 Duplicating
• Enter a new name for the duplicated file and confirm your entry with the
RUN softkey.
The selected file is saved again under the new name in the same workpiece or
in the NC program memory.
Note
It is not possible to duplicate workpieces using this procedure. To duplicate a
workpiece you must first create a new destination workpiece and then copy all
of the source files into the destination workpiece.
6FC5198-6AA60-0BP1 © Siemens AG 1999 All Rights Reserved
SINUMERIK 840C, OEM Version for Windows (BA)
6 Programming