Siemens SINUMERIK 840C Operator's Manual page 182

01.99
Delete Define
config. config.
Explanation of the
softkey bar:
D elete
config .
D efine
config .
Link_o ff
all
Link_o n
all
Flying
synchron.
Link_o n
lin k_switch
Sta rt p os.
Link_o n/sw
© Siemens AG 1999 All Rights Reserved
SINUMERIK 840C, OEM Version for Windows (BA)
Link_off Link_on
all all
When you press a softkey, the prompt "Confirm input" is displayed. Press the
key again to confirm.
The gearbox configuration for the selected following axis is cancelled. You
must first press LINK_OFF. This softkey is identical to the G command "G401
FA".
The configuration defined in the basic display by the parameter settings is
subjected to an integrity check and the gearbox interpolation group is
generated. The default setting for link factors is zero. No position is entered.
The link is deactivated (status LINK_OFF). This softkey is identical to the G
command "G401 LA 1 K 1 .....LA 5 K 5 FA".
Press this softkey twice to perform link_off for the entire gearbox interpolation
group selected by the following axis. The current link factors are retained. The
positions of the main drives are cleared. The status is set to LINK_OFF for
every main axis. This softkey is identical to the G command "G400 FA".
Press this softkey twice to perform link_on for the entire gearbox interpolation
group selected by the following axis. The current entered link factors remain
active. The positions of the main drives are cleared. The status is set to
LINK_ON for every axis. This softkey is identical to the G command "G402
FA".
LINK_ON for the entire gearbox interpolation group selected by the following
axis. The entered link factors are active and flying synchronization is
performed with the entered synchronization positions. This softkey is identical
to the G command "G403 LA 1 LA 1 POS I J...LA 5 LA 5 POS I J FA FAPOS".
After the new link factors have been entered or the link status has been
changed (toggle field) press this softkey twice to activate the entries or
changes. New positions are not taken into account. This softkey is identical to
the G command "G402 LA 1 I J.....LA 5 I J FA".
The entry made in the machine position column is evaluated when the softkey
is pressed, i.e., after the position has been reached, the link is switched on, over
or off depending on the state before the softkey was pressed.
Flying Link_on
synchron. link_switch
6FC5198-6AA60-0BP1
5 Parameters
Start pos
link_On/Sw
5-29