Predefined Procedures - Siemens Sinumerik 840D sl Programming Manual

Tables

17.5 Predefined procedures

1)
2)
3)
4)
Figure 17-1
17.5 Predefined procedures
The call of a predefined procedure triggers the execution of a predefined NCK function. A
predefined procedure does not supply a return value in contrast to a predefined function.
Coordinate system
Identifier Parameter
1.
PRESETON AXIS *
Axis identifier
of
machine axis
PRESETONS AXIS *
Axis identifier
of
machine axis
DRFOF
* As a general rule, geometry or special axis identifiers can also be used instead of the machine axis identifier, as long as the
)
reference is unambiguous.
474
Internal number (e.g. for PLC interface)
Configurability of the G command as a reset setting for the G group on power up, reset or end of
part program (with MD20150 $MC_GCODE_RESET_VALUES):
+ Configurable
- Not configurable
Effectiveness of the G command:
m modal
s Non-modal
Reset setting, see the following machine data
● MD20149GCODE_RESET_S_VALUES (reset position of G groups (fix))
● MD20150GCODE_RESET_VALUES (reset position of G groups)
● MD20151GCODE_RESET_S_MODE (reset behavior of G groups (fix))
● MD20152GCODE_RESET_MODE (reset behavior of G groups)
● MD20154EXTERN_GCODE_RESET_VALUES (reset position of G groups in the ISO mode)
● MD20156EXTERN_GCODE_RESET_MODE (reset behavior of external G groups)
SAG Default setting Siemens AG
MM Default setting Machine Manufacturer (see machine manufacturer's specifications)
Legend for the G group tables
2.
: REAL:
)
Preset offset
G700/G710
context
: REAL:
)
Preset offset
G700/G710
context
3. - 15. 4. - 16.
As 1 ... As 2 ...
As 1 ... As 2 ...
Programming Manual, 01/2015, 6FC5398-1BP40-5BA2
Explanation
Set actual value for the programmed
axes with loss of the referencing sta‐
tus
Set actual value for the programmed
axes without loss of the referencing
status
Deletes the DRF offset for all axes
assigned to the channel.
Fundamentals