Siemens Sinumerik 840D sl Programming Manual page 481

Protection zones
Identifier Parameter
1.
CPROT INT:
Number of the
protection
zone
NPROT INT:
Number of the
protection
zone
Preprocessing / single block
Identifier Parameter
STOPRE
SBLOF
SBLON
Fundamentals
Programming Manual, 01/2015, 6FC5398-1BP40-5BA2
2. 3.
INT: Option REAL: Offset
of the protec‐
0: Protection
tion zone in
area OFF
the first geom‐
1: Preactivate
etry axis
protection
zone
2: Protection
area ON
3: Preactivate
protection
zone with con‐
ditional stop,
only with pro‐
tection zones
active
INT: Option REAL: Offset
of the protec‐
0: Protection
tion zone in
area OFF
the first geom‐
1: Preactivate
etry axis
protection
zone
2: Protection
area ON
3: Preactivate
protection
zone with con‐
ditional stop,
only with pro‐
tection zones
active
17.5 Predefined procedures
4. 5.
REAL: Offset REAL: Offset
of the protec‐ of the protec‐
tion zone in tion zone in
the second the third ge‐
geometry axis ometry axis
REAL: Offset REAL: Offset
of the protec‐ of the protec‐
tion zone in tion zone in
the second the third ge‐
geometry axis ometry axis
Explanation
Preprocessing stop until all prepared blocks in the main
run are executed
Suppress single-block processing
Cancel suppression of the single-block processing
Tables
Explanation
Channel-specific pro‐
tection zone ON/OFF
Machine-specific pro‐
tection zone ON/OFF
481