Control Message From Cp-6010 To Sicam Ak - Siemens SICAM AK Manual

2.5.3.2.1

Control Message from CP-6010 to SICAM AK

Select the values for the parameters
Select the parameter
menu. This represents the control signal from CP-6010 to SICAK AK A.
Enter the same values for the parameters
parameterization of CP-6010.
Enter the values for the parameters IOA1,
Appendix A.1,
= 68,
IOA1 IOA2
Select the following values via the relevant pull-down menu:
─
Control function_(RED)
─
BSE_(RED)
─
PRE_(RED)
─
Priority_(RED)
Afterwards click on Save.
Note
For the parameterization of further control signals, proceed as previously described.
For the configuration of SICAM AK B, proceed according to the same procedure as for SICAM AK A.
The following values must be updated in the SICAM AK B:
• Region
• Component
• CASDU
SICAM RTUs, SICAM AK Redundancy
DC2-026-2.07, Edition 10.2016
Lk_Reg
as Redundancy control message
Lk_Cat
Configuration for CP-6010 to SICAM AK
= 0, = 0).
IOA3
as A/P-control
as C1-CPU; change the value depending on the desired BSE
as BSE itself; change the value depending on the desired PRE
as Priority 0 (lowest)
and via the relevant pull-down menu.
Lk_Comp
via the relevant pull-down
and value as provided in the web
CASDU1 CASDU2
and for the module as provided in
IOA2 IOA3
(for C1-CPU, IOA values are
Unrestricted
Redundancy via CP-6010
115