Parameter Setting - Siemens SICAM AK Manual

1.5.2.4

Parameter Setting

For the configuration of the AU it must be specified, at which slot the power supply must be
fitted.
The following parameters refer to the precise fitting location of the power supply in the module
rack (viewed from the front).
Left top: Parameter
supplies | PS left top fitted
Left bottom: Parameter
supplies | PS left bottom fitted
Right top: Parameter
supplies | PS right top fitted
Right bottom: Parameter
supplies | PS right bottom fitted
•
In the OPM system technique select the HW-Configuration for power supplies under the
node AU-common settings below the M-CPU:
In the Value dropdown list select the corresponding entries according to your configuration.
SICAM RTUs, SICAM AK Redundancy
DC2-026-2.07, Edition 10.2016
AU-common settings | HW-Configuration for power
AU-common settings | HW-Configuration for power
AU-common settings | HW-Configuration for power
AU-common settings | HW-Configuration for power
Unrestricted
Redundancy via SCA-RS
75