Motion-Connect Drive-Cliq Signal Cables With Drive-Cliq Connector And M12; Socket - Siemens SINAMICS S120 Manual
Hide thumbs
Also See for SINAMICS S120:
- Function manual (1094 pages) ,
- Diagnostic manual (947 pages) ,
- Manual (848 pages)
Table of Contents
Advertisement
Note
DRIVE-CLiQ cabinet bushing for DRIVE-CLiQ connectors
For information about the cabinet bushing, see DRIVE-CLiQ cabinet bushings (Page 335).
10.6.1.4
MOTION-CONNECT DRIVE-CLiQ signal cables with DRIVE-CLiQ connector and M12
socket
The MOTION-CONNECT DRIVE-CLiQ signal cables with DRIVE-CLiQ connector and M12
socket have 24 V DC cores. They establish the connection between components with a
DRIVE-CLiQ connection and a direct measuring system equipped with DRIVE-CLiQ ASIC
with 8-pin M12 connector. Measuring systems from third-party manufacturers can be directly
connected to the SINAMICS S120.
Basic cable
The pre-assembled basic cable has eight cores, of which four are used for data transmission
and two for the 24 V supply. It is used to convert from a DRIVE-CLiQ connector (IP20) to an
M12 socket (IP67).
Figure 10-4
AC Drive
Manual, (GH6), 07/2016, 6SL3097-4AL00-0BP5
Cabinet design and EMC for components, Blocksize format
DRIVE-CLiQ basic cable with DRIVE-CLiQ connector and M12 socket
10.6 Connection Methods
363
Advertisement
Table of Contents
