Kenwood TKR-750 Programming Reference Manual page 52

6 EDIT MENU
" Transponder (AUX Output)
This is a timing to send the Transpond code. It can
configure only when no function is assign to
"Function". Select one of "None", "Fore", "After" and
"Both" from the dropdown list.
None Not send the Transpond code.
Sends the Transpond code when receiving
Fore
the Air Remote code.
Sends the Transpond code after processing
Range
After
the received Air Remote code.
Sends the Transpond code when receiving
Both the Air Remote code and after processing
the received Air Remote code.
Default None
" Logic Type (AUX Output)
It can select the status of the signal (Low/High) to
activate or deactivate the function with the Air-Remote
code. It can configure this function only when no
function is assign to "Function". Select "Active Low" or
"Active High" from the dropdown list.
The assigned function activates in
Active Low
Active Low.
Range
The assigned function activates in
Active High
Active High.
Default Active Low
Note: The "Logic Type" configured on the "AUX" tab of the
"Function Port" window appears when "Function" is
configured other than "None". However, you cannot
change the configuration on this window.
6.10.2 AUX Tab.)
" Activation (AUX Transponder)
This is a Transpond code when the function assigned
to the Auxiliary port is activated by the Air Remote
code and the "Transponder" is configured as "Yes".
(Refer to " Transponder (AUX Input), " Transponder
(AUX Output).)
Select a table number configured on the "Encode" tab
of the "Encode/Decode Table" window from the
dropdown list. (Refer to 6.8 "Encode/Decode Table"
Window.)
Range None, Enc Table 1 - 32
Default None
Note: You can use Single Tone as the Transpond code when
the DTMF signalling is configured.
Tone (Aux Transponder).)
47
" Deactivation (AUX Transponder)
" Single Tone (Aux Transponder)
(Refer to
(Refer to " Single
Field Programming Reference (FPRG)
This is a Transpond code when the function assigned
to the Auxiliary port is deactivated by the Air Remote
code and the "Transponder" is configured as "Yes".
(Refer to " Transponder (AUX Input), " Transponder
(AUX Output).)
Select a table number configured on the "Encode" tab
of the "Encode/Decode Table" window from the
dropdown list. (Refer to 6.8 "Encode/Decode Table"
Window.)
Range None, Enc Table 1 - 32
Default None
Note: You can use Single Tone as the Transpond code when
the DTMF signalling is configured.
Tone (Aux Transponder).)
It can use Single Tone for the Transpond code.
Use Single Tone for the Transpond
Checked
code.
Range
Not use Single Tone for the
Unchecked
Transpond code.
Default Unchecked
Note: You cannot individually select Single Tone for Aux
Transponder Activation and Deactivation.
(Refer to " Single
Version: 1.01