Table of Contents
Advertisement
Installation
5
Instruction
5 Installation
5.1 Instruction
26 | 124
Building Technologies
Fire safety
WARNING
Voltage
Electric shock
●
Installation work may only be undertaken by qualified staff and when the
system is de-energized.
NOTICE
Electrostatics
Damage to electronics
●
Suitable protective measures must be taken when working with electronics
modules.
●
Specialist electrical engineering knowledge is required for installation.
●
Only an expert is permitted to carry out installation work.
Incorrect installation can take safety devices out of operation unbeknown to a
layperson.
The installation must comply with all applicable national and local regulations.
●
The panel must be installed in a dry, clean and well vented room.
●
The panel and its components must be protected against dampness and
interfering external influences such as dust, great temperature fluctuations and
mechanical stress.
●
The panel must be installed in a place freely accessible to authorized staff and
the emergency services.
●
The panel must be fitted to a level, non-vibrating wall surface with load bearing
capacity using suitable mounting materials (e.g. screws and plugs).
●
The installation surface and selected wall must be suitable for the weight of the
panel including the batteries used.
●
Installation is not permitted in rooms with high levels of electromagnetic
interference, e.g. in control rooms or right next to power cables and inductive
loads.
Mounting options
There are two options for mounting the panel:
●
Surface mounting [➙ 28]
●
Semi flush mounting, refer to document A6V10893024, see chapter 'Applicable
documents [➙ 9]'
A6V10421795_en--_g
2016-11-18
Advertisement
Table of Contents
