Siemens SIMATIC Ident Function Manual page 45

Results
Apply the correct data type that is assigned to the ATTRIBUTE value at the "IDENT_DATA"
input of the instruction so that the data can be correctly interpreted. Only an Array of Byte
can be created at the "Ident Data" parameter . The conversion to the corresponding data
type must be done manually.
Table 4- 25 ATTRIBUTE "0x81" (data type "IID_READSTAT_81_RF2_3_U")
Name
status info
hardware
hardware version
loader version
firmware
firmware version HB
firmware_version_LB
driver
driver version
interface
baud
reserved1
reserved2
reserved3
distance limiting SLG
multitag SLG
field ON control SLG
field ON time SLG
sync SLG
status ant
stand by
MDS control
Table 4- 26 ATTRIBUTE "0x86" (data type "IID_READSTAT_86_RF300")
Name
status info
FZP
ABZ
CFZ
SFZ
CRCFZ
BSTAT
ASMFZ
reserved0
Ident profile, Add-on instruction for Rockwell systems
Function Manual, 01/2019, C79000-G8976-C410-03
Type Comment
SINT SLG status mode
SINT Type of hardware
INT Version of hardware
INT Version of loader
SINT Type of firmware
SINT Version of firmware
SINT
SINT Type of driver
INT Version of driver
SINT Type of interface (RS 232/RS 422)
SINT Baudrate
SINT Reserved
SINT Reserved
SINT Reserved
SINT Distance limiting of SLG
SINT Multitag SLG
SINT Field ON control
SINT Field On time
SINT Synchronization with SLG
SINT Status of antenne
SINT Time of standby after command
SINT Presence mode
Type Comment
SINT SLG status mode
SINT Error counter passive: distortion without communication
SINT Dropout counter
SINT Code error counter
SINT Signature error counter
SINT CRC-error counter
SINT Status of last command
SINT Error counter for host interface (ASM)
SINT[17]
Configuring the instructions
4.5 Programming add-on instructions
45