Siemens SIMATIC Ident Function Manual page 80

Configuring the instructions
4.6 Programming the Ident profile
Structure of the configuration data attachment of "WRITE-CONFIG"
For RF68xR:
● When CONFIG = 0x01:
Reset_Reader; LEN_DATA = 0x00
● When CONFIG = 0x03:
When replacing a module, it is possible to read all the configuration data from the
CM/reader and to store it on the controller. When the module is replaced, this data can
then be loaded on the reader from the controller. The command "WRITE-CONFIG" (0x03)
is used for the download to the CM/reader and "READ-CONFIG" for the upload from the
reader.
LEN_DATA = Size of the configuration data + 6 bytes
● When CONFIG = 0x80:
The structure of the send buffer corresponds to that of the block "Set_Param (Page 38)".
LEN_DATA = 0x08
For RF200, RF300, RF620R, RF630R
Table 4- 66 For RF200, RF300, RF620R, RF630R when "CONFIG = 0x03"
Byte 1 2...5
Value 0x04 0x00
With the readers named in the title of the table the value "0x0A" (LEN_DATA = 0x10) is used in byte 6. In the MOBY I
1)
migration in RF300 readers of the second generation the value "0x05" (LEN_DATA = 0x0B) is used.
80
Byte
0
2
6
10 ... end "DATA"
6 7...8 9
1)
0x0A 0x00 scanning_
0x05 time
Name
Structure identifier (2 bytes)
Length information (4 bytes)
Length of the version identifier and parameter block
Version identifier (4 bytes)
Based on the identifier, you can uniquely identify the configuration.
This is a time stamp in Linux format.
The time stamp indicates how many seconds have passed since
January 1, 1979, 00:00 (midnight). The identifier is assigned when a
configuration is generated.
Parameter block
10 11 12
param op- distance_
tion_1 limiting
Ident profile, Add-on instruction for Rockwell systems
Function Manual, 01/2019, C79000-G8976-C410-03
13...14 15 16
No. of field_on_ field_on_
tran- control time
sponders