Siemens SIMATIC Ident Function Manual page 50

Configuring the instructions
4.5 Programming add-on instructions
Table 4- 31
Parameter
ATTRIBUTE
LEN_ID
EPCID_UID
IDENT_DATA
With RF300 first generation with the attribute "0x83" the values can only be queried with ISO
1)
transponders. With RF300 second generation with this attribute the values can be queried with all
transponder types. In "General Mode" only this attribute functions.
Results
Table 4- 32 ATTRIBUTE "0x04" ("IID_TAG_STATUS_04_RF300" data type)
Name
reserved
status info
UID
MDS type
Lock state
Reserved1
50
Explanation for the instruction "Tag_Status"
Data type
SINT
SINT
SINT[62]
SINT[10]
Type Comment
SINT
SINT MDS status mode
SINT[8]
SINT Type of MDS
SINT Write Protection Status EEPROM
SINT[6]
Default values Description
0x00 Identifier of the status modes / possi-
ble entries:
RF200: 0x83
•
RF300: 0x04, 0x82, 0x83
•
RF620R, RF630R: 0x84, 0x85
•
0x00 Length of the EPC-ID/UID
Default value: 0x00 ≙ unspecified
single tag access (RF68xR)
0 Buffer for up to 62 bytes EPC-ID, 8
bytes UID or 4 bytes handle ID.
2 - 62-byte EPC-ID is entered at
•
the start of the buffer (length is set
by "LEN_ID")
8-byte UID is entered at the start
•
of the buffer ("LEN_ID = 8")
4-byte handle ID must be entered
•
in the array element [5]-[8]
("LEN_ID = 8")
Default value: 0x00 ≙ unspecified
single tag access (RF620R, RF630R)
0 Event values depending on attributes
Note:
When necessary, an array of any size
can be transferred to this parameter.
Note that the array must be ≥ 10 bytes
long (e.g. "SINT[12400]").
Ident profile, Add-on instruction for Rockwell systems
Function Manual, 01/2019, C79000-G8976-C410-03
1)