Siemens SIMATIC Ident Function Manual page 81

Table 4- 67 Bytes of the "PARAM" parameter
Byte Value
Byte 9 scanning_
time
Byte 10 param
Ident profile, Add-on instruction for Rockwell systems
Function Manual, 01/2019, C79000-G8976-C410-03
RFID system Meaning
RF200, 0x00 (reserved)
RF300
RF600 "scanning_time" describes the radio profile according to EPC Global. Set the cor-
rect standard according to the country in which you want to operate the reader.
Please check which standard and which reader variant is applicable to your coun-
try before you select a wireless profile.
Value Description
0x00 No standard selected; the
error "0x15" is output
0x01 Reader works with the de-
fault wireless profile. Value
of the default wireless profile:
0x02 ETSI new: EU, EFTA, Tur-
key;
4-channel plan
0x03 ETSI old: EU, EFTA, Turkey;
readers commissioned after
December 31, 2009, must
not be operated with this
setting.
0x04 FCC: e.g. USA, Canada,
Mexico
0x05 Reserved
0x06 China
0x07 Thailand
0x08 Brazil
0x09 South Korea
0xC0 India
Note: If you select country profiles other than those defined for the particular read-
er variant, the error message "09" is acknowledged.
RF200, Setting for the RFID mode and presence check
RF300
Bit Description
7 ... 5 Presence check and transponder control:
•
•
•
4 To be assigned the value "0x00".
3 ... 0 RFID mode:
•
•
0x00 = Operation without presence check
0x01 = Operation with presence check
Antenna is permanently switched on.
0x04 = Operation without presence check
Antenna is switched off. The antenna is only switched on when one
of the following commands is sent: Read, Write, Init, Tag-Status
0x05 = Without multitag mode with communications module ASM
475, ASM 456, RF170C, RF180C
0x06 = With multitag mode with communications module ASM 475,
ASM 456, RF170C, RF180C
Configuring the instructions
4.6 Programming the Ident profile
ETSI FCC
-- --
ETSI new FCC
X --
X --
-- X
-- --
-- --
-- X
-- X
-- X
X --
CMIIT
--
China
--
--
--
--
--
--
--
--
81