Mitsubishi Electric GOT2000 Series Connection Manual page 213

(2) Setting for the built-in MP2300S Ethernet and 218IF-02
Transmission parameter
setting
Transmission parameter
detailed setting
Message communication of
connection parameter setting
*1 Set the same the Node IP Address (Remote Station's IP Address) and the Node Port (Remote Station's Port Number) as the
Local IP Address and the Local Port (Local Station's Port Number) on the GOT side.
For the Local IP Address and the Local Port (Local Station's Port Number) on the GOT side, refer to the following.
➠
6.3.3 ■4. Connected Ethernet Controller Setting
Item
IP Address
Subnet Mask
Gateway IP Address
Device name
Engineering Port
Response Time
Count of Retry
(Number of Retries)
Connection Number
Local Port
*1
Node IP Address
*1
Node Port
Connection Type
Protocol Type
Code
Node Name
Set value
[ ].[ ].[ ].[ ]
[ ].[ ].[ ].[ ]
PLC side setting
[ ].[ ].[ ].[ ]
Arbitrary Up to 16 one-byte characters
For a connection with software
256 to 65535
0
Not required for
0
• Range of built-in MP2300S
Ethernet: 1 to 4
1
• Range of 218IF-02: 1 to 20
10500
[ ].[ ].[ ].[ ]
[ ]
UDP
(recommended)
Extended
MEMOBUS
BIN
Up to 32 one-byte characters
Arbitrary
(16 two-byte characters)
6.3 Ethernet Connection
Range
PLC side IP
address
MPE720
communication
with GOT
256 to 65534
6
IP address
of GOT
Port No.
of GOT
TCP/UDP
Extended
MEMOBUS,
MEMOBUS,
MELSEC,
None,
MODBUS/TCP
RTU, BIN, ACII
6 - 31