Device Range That Can Be Set - Mitsubishi Electric GOT2000 Series Connection Manual

15.4 Device Range that Can Be Set

The device ranges of controller that can be used for GOT are as follows.
Note that the device ranges in the following tables are the maximum values that can be set in GT Designer3.
The device specifications of controllers may differ depending on the models, even though belonging to the same series.
Please make the setting according to the specifications of the controller actually used.
When a non-existent device or a device number outside the range is set, other objects with correct device settings may not
be monitored.
■1. Setting item
(1) S7-300/400 series and S7(Ethernet)
Item
Device
Information
Network
15 - 24
15.4 Device Range that Can Be Set
Set the device name, device number, and bit number.
The bit number can be set only when specifying the bit of word device.
Displays the device type and setting range which are selected in [Device].
Set the monitor target of the set device.
Host Select this item to monitor the controller specified as the host station in the GOT utility (setup).
Select this item to monitor a controller other than the one specified as the host station.
• SIEMENS S7-300/400
Other Set the MPI address of the controller monitored.
• SIEMENS S7(Ethernet)
Set the network number and the station number of the controller monitored.
POINT POINT POINT
Device settings of SIEMENS PLC (S7-300/400 series, S7(Ethernet))
(1) When setting a bit device as a bit device
Set the device using the format of byte address (DEC) + bit address (0 to 7).
Device name
(2) When setting a bit device as a word device
Set the device number.
For the device name setting, enter "W" after the bit memory device name.
Device name
(W added)
Description
Device number
Bit address (0 to 7)
Byte address (DEC)
Device number
(Setting with even number)