Mitsubishi Electric GOT2000 Series Connection Manual page 254

■3. GOT Ethernet Setting
The GOT can be connected to a different network by configuring the following setting.
(1) GOT IP address setting
Set the following communication port setting.
• Standard port (When using GT25-W, port 1)
• Extension port (When using GT25-W, port 2)
(2) GOT Ethernet common setting
Set the following setting which is common to the standard port and the extension port, or port 1 and port 2.
• [Default Gateway]
• [Peripheral S/W Communication Port No.]
• [Transparent Port No.]
(3) IP filter setting
By configuring the IP filter setting, the access from the specific IP address can be permitted or shut off.
For the detailed settings, refer to the following manual.
➠
■4. Connected Ethernet Controller Setting
Item
Host
Net No.
*3
Station
Unit Type
*1
IP address
*2
Port No.
Communication format
*1
*2
*3
7 - 26
7.3 Ethernet Connection
1.1.2 GOT Ethernet Setting
The host is displayed.(The host is indicated with an asterisk (*).)
Set the network No. of the connected Ethernet module.
(Default: blank)
Set the station No. of the connected Ethernet module.
(Default: blank)
YOKOGAWA (fixed)
Set the IP address of the connected Ethernet module.
(Default: blank)
Set the port No. of the connected Ethernet module.
(Default: 12289)
Select a communication protocol.
*1
(Default: UDP)
Set the same IP address and communication format as those of the PLC side.
Set the port No. of the host link service used on the PLC side.
Set different values for [GOT Station] of [Detail Setting] and [Station] of [Connected Ethernet Controller Setting].
➠
■2. Communication detail settings
Description Set value
―
1 to 239
1 to 64
YOKOGAWA (fixed)
PLC side IP
address
12289, 12291
UDP, TCP