Siemens SINUMERIK 840Di Function Manual page 519

Data Lists
5.1 Machine data
5.1
5.1.1 NC-specific machine data
Number Identifier: $MN_
10713 M_NO_FCT_STOPRE
10714 M_NO_FCT_EOP
11100 AUXFU_MAXNUM_GROUP_ASSIGN
11110 AUXFU_GROUP_SPEC[n],
5.1.2 Channel-specific machine data
Number Identifier: $MC_
20110 RESET_MODE_MASK
20112 START_MODE_MASK
20270 CUTTING_EDGE_DEFAULT
20800 SPF_END_TO_VDI
22000 AUXFU_ASSIGN_GROUP
22010 AUXFU_ASSIGN_TYPE
22020 AUXFU_ASSIGN_EXTENSION
22030 AUXFU_ASSIGN_VALUE
22035 AUXFU_ASSIGN_SPEC
22040 AUXFU_PREDEF_GROUP
22050 AUXFU_PREDEF_TYPE
22060 AUXFU_PREDEF_EXTENSION
22070 AUXFU_PREDEF_VALUE
22080 AUXFU_PREDEF_SPEC
22100 AUXFU_QUICK_BLOCKCHANGE
22110 AUXFU_H_TYPE_INT
22200 AUXFU_M_SYNC_TYPE
Auxiliary Function Output to PLC (H2)
Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0
Description
M function with preprocessing stop
M function for spindle active after NC RESET
Maximum number of user-defined auxiliary functions
per channel
Group-specific output behavior
Description
Definition of control initial setting after part program
start.
Definition of control initial setting after powerup and
on RESET or at end of part program
Basic setting of tool cutting edge without programming
Subprogram end to PLC
Auxiliary function group
Type of auxiliary function
Auxiliary function extension
Auxiliary function value
Output specification (user-def. AuxFu)
Predefined auxiliary function groups
Predefined auxiliary function type
Predefined auxiliary function extension
Predefined auxiliary function value
Output specification (predefined auxiliary function)
Block change without delay
Type of H auxiliary functions
Output timing for M functions
5
5-1