Siemens SINUMERIK 840Di Function Manual page 671

2.10 System settings for power-up, RESET/part-program end and part-
2.10
program start
Concept
The control system response can be altered for functions such as G codes, tool length
compensation, transformation, coupled axis groupings, tangential followup, and
programmable synchronous spindle after
• Power up (power ON),
• Reset/part program end and
• Part program start
by machine data
MD20110 $MC_RESET_MODE_MASK
MD20150 $MC_GCODE_RESET_VALUES and its extension
MD20152 $MC_GCODE_RESET_MODE (specification of initial controller setting
on reset) and
MD20112 $MC_START_MODE_MASK (specification of initial controller setting
after part program start).
For certain applications (e.g., grinding) it is advisable not to capture the reset position of
individual functions until part program start. This is possible through the appropriate setting
of MD20110, MD20150, MD20152 and MD20112.
Table 2-11
Status
Power up (POWER ON)
RESET/part program end
Part program start
Procedure
Select the desired system response.
• After power-up (POWER ON)
Mode Group, Channel, Program Operation, Reset Response (K1)
Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0
2.10 System settings for power-up, RESET/part-program end and part-program start
Change system settings by means of MD
MD20110 $MC_RESET_MODE_MASK, Bit 0 = 0 or 1
Can be changed in MD
MD20110 $MC_RESET_MODE_MASK
MD20150 $MC_GCODE_RESET_VALUES
MD20110 $MC_RESET_MODE_MASK
MD20150 $MC_GCODE_RESET_VALUES
MD20152 $MC_GCODE_RESET_MODE
MD20110 $MC_START_MODE_MASK and
MD20112 $MC_RESET_MODE_MASK
Detailed Description
2-135