Siemens SINUMERIK 840D sl Turning Operating Manual page 165

Cascaded search
You can start another search from the "Search target found" state. Each time a search target
is found, it is possible to continue cascading arbitrarily.
Note
Another cascaded block search can be started from the stopped program execution only if the
search target has been found.
Preconditions
● You have selected the desired program.
● The controller is in the reset state.
● The desired search mode is selected.
Toggling between search pointer and search positions
Further information
You can find further information on the block search function in the Basic Functions Function
Manual.
See also
Selecting a program (Page 155)
Turning
Operating Manual, 06/2019, A5E44903486B AB
NOTICE
Risk of collision
Pay attention to a collision-free start position and appropriate active tools and other
technological values.
If necessary, manually approach a collision-free start position. Select the target block
considering the selected block search variant.
Press the "Search pointer" softkey again to exit the "Search Pointer"
window and return to the program window to define search positions.
- OR -
Press the "Back" softkey.
You have now exited the block search function.
Machining the workpiece
6.7 Starting machining at a specific point
165