Siemens SINUMERIK 840D sl Turning Operating Manual page 588

Programming technology functions (cycles)
10.5 Contour milling
from the inside to the outside. The direction is determined by the machining direction (up-cut or
down-cut). If an island is located in the pocket, the cycle automatically takes this into account
during stock removal.
Note
Execution from external media
If you execute programs from an external drive (e.g. local drive or network drive), you require
the "Execution from external storage (EES)" function.
For additional information, please refer to the following references:
SINUMERIK Operate Commissioning Manual
Clamping the spindle
For ShopTurn, the "Clamp spindle" function can be set up by the machine manufacturer.
Input simple
For simple machining operations, you have the option to reduce the wide variety of parameters
to the most important parameters using the "Input" selection field. In this "Input simple" mode,
the hidden parameters are allocated a fixed value that cannot be adjusted.
If the workpiece programming requires it, you can display and change all of the parameters
using "Input complete".
Machining type
For solid machining, you can select the machining type (roughing or finishing). If you want to
rough and then finish, you have to call the machining cycle twice (block 1 = roughing, block 2
= finishing). The programmed parameters are retained when the cycle is called for the second
time.
During insertion with oscillation, the message "Ramp path too short" will appear if the tool is less
than the milling cutter diameter away from the insertion point along the ramp, or the machining
depth is not reached.
● Reduce the insertion angle if the tool remains too close to the insertion point.
● Increase the insertion angle if the tool does not reach the machining depth.
● If necessary, use a tool with a smaller radius of select a different insertion mode.
588
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Machine manufacturer
Various defined values can be pre-assigned using setting data.
Please refer to the machine manufacturer's specifications.
Operating Manual, 06/2019, A5E44903486B AB
Turning