Simultaneous Recording During Machining Of The Workpiece - Siemens SINUMERIK 840D sl Turning Operating Manual
Hide thumbs
Also See for SINUMERIK 840D sl Turning:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
Simulating machining
7.4 Simultaneous recording during machining of the workpiece
7.4
Simultaneous recording during machining of the workpiece
If the view of the work space is blocked by coolant, for example, while the workpiece is being
machined, you can also track the program execution on the screen.
Procedure
Note
● If you switch-on simultaneous recording after the unmachined part information has already
been processed in the program, only traversing paths and tool are displayed.
● If you switch-off simultaneous recording during machining and then switch-on the function
again at a later time, then the traversing paths generated in the intermediate time will not be
displayed.
244
Software option
You require the option "Simultaneous recording (real-time simulation)" for the
simultaneous recording.
1.
Load a program in the "AUTO" mode.
2.
Press the "Sim. rec." softkey.
3.
Press the <CYCLE START> key.
The machining of the workpiece is started and graphically displayed on
the screen.
4.
Press the "Sim. rec." softkey again to stop the recording.
Operating Manual, 06/2019, A5E44903486B AB
Turning
Advertisement
Table of Contents
