Siemens SINUMERIK 840D sl Turning Operating Manual page 591

Parameter Description
EP Maximum pitch of helix – (for helical insertion only)
ER Radius of helix – (for helical insertion only)
The radius cannot be any larger than the milling cutter radius; otherwise, material will
remain.
EW Note:
During insertion with oscillation, the message "Ramp path too short" will appear if the tool
is less than the milling cutter diameter away from the insertion point along the ramp. If this
occurs, please reduce the angle of insertion.
Lift mode Lift mode before new infeed
If the machining operation requires several points of insertion, the retraction height can be
programmed:
● To retraction plane
● Z0 + safety clearance
When making the transition to the next insertion point, the tool returns to this height. If
there are no elements larger than Z0 (X0) in the pocket area, then Z0 (X0) + safety
clearance can be programmed as the lift mode.
FS Chamfer width for chamfering - (only for chamfering machining)
ZFS Insertion depth of tool tip (abs or inc) - (for chamfering machining only)
Parameters in the "Input simple" mode
G code program parameters
Input
PRG
● Name of the program to be generated
● Automatic
Automatic generation of program names
Milling direction
● Climbing
● Conventional
RP Retraction plane
F Feedrate
Turning
Operating Manual, 06/2019, A5E44903486B AB
ShopTurn program parameters
● simple
T
D
mm F
* S / V
Programming technology functions (cycles)
Tool name
Cutting edge number
Feedrate
Spindle speed or constant
cutting rate
10.5 Contour milling
Unit
mm/rev
mm
Degrees
mm
mm
mm
mm
mm/min
mm/rev
rpm
m/min
591