Simulating The Program Block By Block - Siemens SINUMERIK 840D sl Turning Operating Manual
Hide thumbs
Also See for SINUMERIK 840D sl Turning:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
7.8.2
Simulating the program block by block
You have the capability of controlling the program execution during the simulation, i.e. to
execute a program, e.g. program block by program block.
Procedure
Switching a single block on and off
Turning
Operating Manual, 06/2019, A5E44903486B AB
1.
Simulation is started.
2.
Press the "Program control" and "Single block" softkeys.
3.
Press the "Back" and "Start SBL" softkeys.
The pending program block is simulated and then stops.
4.
Press "Start SBL" as many times as you want to simulate a single pro‐
gram block.
5.
Press the "Program control" and the "Single block" softkeys to exist the
single block mode.
Press the <CTRL> and <S> keys simultaneously to enable and disable the
single block mode.
Simulating machining
7.8 Program control during the simulation
253
Advertisement
Table of Contents
