Figure 2-10
2.2.2
Parameterization
2.2.2.1
Overview
Machine data: Transformation data in general
The following machine data is used to define transformation data sets in a channel:
● MD2xxxx $MC_TRAFO_TYPE_<n> (definition of the <n>th transformation in the channel)
● MD2xxxx $MC_TRAFO_AXES_IN_<n> (axis assignment for the <n>th transformation in the
channel)
● MD2xxxx $MC_TRAFO_GEOAX_ASSIGN_TAB_<n> (assignment of geometry axes to
channel axes for transformation <n>)
● MD2xxxx $MC_TRAFO_INCLUDES_TOOL_<n> (tool handling with active <n>th
transformation)
where <n> = 1, 2, 3, ... max. number of transformation data sets
For TRACYL (type 512, 513, or 514), no more than two transformation data sets may be
parameterized in a channel:
● MD2xxxx $MC_TRAFO_TYPE_<x> = <TRACYL type>
● MD2xxxx $MC_TRAFO_TYPE_<y> = <TRACYL type>
Transformations
Function Manual, 06/2019, A5E47435470B AA
Parallel limited longitudinal groove with TRACYL with groove side offset
M1: Kinematics transformation
2.2 TRACYL cylinder surface transformation (option)
43