Siemens 6GK1 901-1GB01 System Manual page 23

10. Spread out the cores according to
their colors on the contact elements
of the FC RJ-45 plug 180 4x2.
14. Press the blue/blue-white and
brown/brown-white pairs into the
color coded wire guide slits.
15. Cut the wires so that they extend by
1-2 mm (see scissors symbol).
16. Push the cable into position as
shown in the picture (see arrows).
Make sure that the wires remain in
the guide slits and close the cover.
Note: The edge of the cable jacket
must be between the two spikes as
shown in the picture.
Passive network components
System Manual, 02/2013, C79000-G8976-C282-01
Instructions for fitting connectors, attachments and devices
11. Bend the contact element to
approx. 45°.
12. Push the pairs with colors
green/green-white and
orange/orange-white into the lower
part of the contact element
according to the color markers.
Make sure that the wires sit
correctly in the wire guide slits.
Note: Tweezers can be used to thread
the wires into the wire guide slits.
17. Turn the locking mechanism with
your hand as far as possible in the
direction of the arrow.
18. Insert a screwdriver (3 mm) into the
slit in the locking mechanism and
turn it as far as the limit stop.
The connector is correctly locked whe
the opening of the locking mechanism
is at the side and the side edges are
flush with the connector.
N ote: If necessary, the connector can
be closed with pliers.
2.3 Electrical networks
13. Press down the contact element as
far as the limit stop.
Notes:If the wires do not completely fill
the wire guide slits, the cable must be
stripped again.
If the wires extend beyond the wire
guide slits, the wires must be
shortened.
Once the IE FC RJ-45 Plug 180 4x2
has been fitted to a cable it may no
longer be fitted to cables with a
different cable cross-section.
Removal from an RJ-45 jack
1. If space is limited, release the plug
using a screwdriver (blade 3 mm
wide).
Notice: When releasing, do not pull on
n
the plug!
23