Instructions for fitting connectors, attachments and devices
2.3 Electrical networks
6. Close the cover.
Replacing the insert
1. Remove the locking screw of the
insert.
2. Pull the insert forward as far as the
limit stop.
5. Push the insert into the base model
as far as the limit stop.
2.3.10.2
Assembling IE FC TP standard cable 4x2 GP and IE FC RJ-45 modular outlet
Introduction
The individual steps required to assemble an IE FC TP standard cable 4x2 (22 AWG) and an
IE FC RJ-45 modular outlet are explained below. Note the information in the assembly
instructions of the plug.
40
7. Tighten the two cover screws.
8. Push the insert into the base model
as far as the limit stop.
9. Tighten the securing screw of the
insert until the insert is flush with
the base module.
3. Unlock the insert by pressing on
the locking spring that is now
accessible from above.
6. Tighten the securing screw of the
insert until the insert is flush with
the base module
4. Remove the insert completely from
the base module.
Passive network components
System Manual, 02/2013, C79000-G8976-C282-01